PWM Controller Styro

The PWM Controller Styro with integrated power supply for all CNC-Styrocut Models

Two indepandable switching channels, one with variable voltage for the hot wire and the other to turn 220V accessories On/ OFF.

Description

- Integrated power supply with 0-50V/ 4A or 0-80V/ 4A, needs PWM signal,
- One outlet 220V/10 amps with a total of 10 amps for both,
- Separate signals are used to control the relays,
- Relays are magnetic to permit inductive surge loads at motor startup,
- Main power switch with lamp,
- Separate indicator lamps for each circuit,
- Can be used with any parallel port CNC controllers,
- 12V working voltage on board.


To operate the relays with DeskCNC, the e.g. CW/CCW buttons are clicked. Dragging the "Spindle override" slider will vary the voltage on thevariable heating wire outlet over the full range of voltage.

To control the circuits within a program, M03 turns on both outlets, M05 turns off both. Both circuits are turned off at the end of a program. Both M codes can also be executed with the MDI function. The variable voltage is controlled with the S comand. S0.0 = 0 volts and S100 = 115 volts, with varying percentages in between.


Content of delivery:

- Assembled and tested control box in a black PVC housing.
- 1.8m DeskCNC data cable, power cord,
- Plug compatible, panel mount wiring assembly for the DeskCNC controller,
- Manual.